Engine Cover After Polishing and Some Things Done To The Frame

One of the side cover's after careful sanding using increasing grits of sand paper from 120# to #1000 before buffing, using two grades of compound.

A new tank mounting bracket is fabricated to replace the existing one that has been cut off with an angle grinder and 1mm cutting disk.

Dents in the frame are filled up with brazing, then ground down with an angle grinder and finished off with a 120# sanding disk.

 

The side stand lug, was broken off, and the remnant's removed with angle grinder cutting disk, and heat. A new bracket has been procured and will be welded on, once the correct angle can be determined.